The heat wave call was avoidable.
Capacitors do not fail randomly. They drift out of spec first, and a meter catches that in April for the price of a service visit. Coils do not clog overnight either. When we get the call on the third ninety-five degree day, the failure has usually been building since spring.
The same is true in reverse for heat. A flame sensor coated in carbon, a tired blower bearing, a boiler running on dirty transfer coils. All of it shows up on a fall inspection and none of it is an emergency in September.
What is actually on the checklist.
Spring cooling: clean the condenser coil, check the refrigerant charge, test the capacitor and contactor, clear the condensate drain and test the safety switch, check airflow and the filter, and verify the temperature split across the coil.
Fall heating: inspect and clean the burners, clean the flame sensor, test the safeties and limits, check venting and combustion, change or check the filter, verify the thermostat calls the right stages, and on boilers check the low-water cutoff, pressure, and relief valve.
No membership branding. Just service, scheduled ahead.
We are not going to invent a gold tier with a monthly charge. You book the seasonal visit, we do the work, and we reach out when your season comes around again so it does not slip.
Book cooling in April or May and heating in September or October. Those months are open. July and January are not.
